List Of Programme Commands; To Set Machine Parameters - Saeco MEGACOLD L Notice Originale

20
9.2

LIST OF PROGRAMME COMMANDS

ACCESS TO SUBMENUS
Command 01
Command 02
Command 03
Command 04
Command 05
Command 06
Command 07
Command 08
Command 09
Command 10
Command 11
Command 15
E
Command 26
N
COMMANDS 27÷39
G
Mode EXECUTIVE
L
I
Mode BDV
S
Mode MDB
H
TO SET REFRIGERATION
Command 40
Command 41
Command 43
Command 44
Command 45
Command 46
Command 48
TO SET MACHINE
Command 49
Command 50
Command 55
Command 56
Command 58
Command 59
Command 60
Command 61
Command 62
Command 63
Command 64
Command 66-67
Command
68
Command
69
Command
70
Command
73
Command
74
Command
75
Command
76
Command
80
Command
81
Command 85
Command 90
Command 91
Command 92
Command 93
Command 94
Command 95
Command 96
Machine test
Calls submenu for setting the
Recall of price setting
Calls submenu for setting discounted
Recall the price reference setting submenu
Setting the product
Display of sales for full price
Displays sales for selection discounted price
Displays totals cashed not
Displays totals clearable
Setting the selection sequences
Concatenated menus
Child-proof device activation (if present)
see paragraph:
PAYMENT SYSTEMS.
see paragraph BDV.
see paragraph MDB.
PARAMETERS
Enabling probe error control: (only on Master) / Select refrigeration unit type on
SLAVE
Sets cabinet temperature
End defrosting temperature setting
frequency
Sets defrost cycle
Setting the cut-out duration for the refrigeration safety device
Setting the internal limit temperature: (only on Master) / Setting the trigger
temperature for the refrigeration safety device
Setting trays with refrigeration safety device
PARAMETERS
Enable/disable slave spirals
Machine configuration
Price display enable multifunction (if present)
Setting the back-lighting parameter
Enabling the Slave mode from
Stroke counter
Erases the memory
Reset security/access code
Enable discount
mono/multivend
Set the
Sets the message display
Internal temperature and evaporator temperature display
Setting displayed currency description
Chooses functioning mode of
Buzzer operation option
photoelectric cells
Enabling the
Photocell test
Setting the operating parameters of the photocell
System's operating options ("FTC Options ")
Cloning
vend data
Fetch
Display of checksum and main and
Select AUDIT protocol
Enter machine identification data
Clear sales data
Displays the temperature status
Displays the last 10
Enter user message 1 (max 63 characters)
Enter user message 2 (max 63 characters)
clock & daily timers
submenu
prices
code
selection
clearable
USING THE EXECUTIVE STD/EXECUTIVE PRICE HOLDING
(if present)
Stand-Alone
language
the coin mechanism
power board software version.
/ telemetry enablement
over the last 24 hours
power-offs
MEGACOLD L – Issue 01
barrier