Functions - Gewiss CHORUS GW 10 767 Mode D'emploi

The actuator can function in shutter or blind mode, and is capable of
handling actuation following priority, scene and alarm commands. This
device sends the bus information on the relay status (ON = contact closed,
OFF = contact open) when it is switched on, on receiving a command and
when it is activated manually.
The operating methods can be used simultaneously.
The actuator is fitted inside a standard flush-mounted box, in the space of
two Chorus modules.
2.2

FUNCTIONS

The motor actuator is able to handle movement, alarm and priority
commands simultaneously. When more than one mode is activated at the
same time, the actuator will enable the one with highest priority status.
The priority of the various functions, from maximum to minimum, is as
follows:
• Relay status on loss of power to the bus
• Priority controls
• Alarms control
• Relay status on reinstatement of power to the bus
• Shutters/blinds movement, scene management
The two green status indicator LEDs light up when the contacts with the
respective relays are closed.
Shutter Movement Handling
It raises or lowers the shutters, or stops the movement when it receives the
relative command.
If the Stop command is not sent, the motor will only stop at the end of the
Movement Time: The shutters must therefore be fitted with stroke end
sensors or an autonomous clutch.
Blind movement handling
WARNING: In order to fully exploit this mode, the blinds
must be able to mechanically orientate their laths with
short UP/DOWN movements performed by the motor.
17
MAX PRIORITY
MIN PRIORITY