For Your Safety; Tool Specifications - Würth CLL 06 Notice D'utilisation

CLL 06.book Seite 7 Freitag, 21. Juli 2006 11:03 11
GB
Working safely with this ma-
chine is possible only when the
operating and safety informa-
tion are read completely and
the instructions
therein are strictly followed.
Do not remove the label on the
side of the housing.
Laser radiation Laser class 2 M
2
(635 nm)
complying with EN 60 825-1
For further notes on safety refer to the enclosed sheet
Line laser
Article number
Laser type
Laser class
Beam pulsation for operation with hand receiver
Levelling accuracy of line laser
with hand receiver
1)
Line accuracy ±2 mm on a line length of 10 m
Length of horizontal lines
Power supply (operating life)
Recommended operating temperature
Protection class
Weight (Tool + mounting device)
1)
Pay particular attention when working with the hand receiver at larger distances – the
value is added to the levelling accuracy. Maximum accuracy is achieved close to the cross
point.
2)
Operating temperatures above 50 °C can damage the laser diodes. (Caution when
keeping devices in the car in the summer season).

For Your Safety

contained
Do not direct the laser beam at other
persons. Since the laser beam is of the
bundled type, check the beam path
over a relatively long distance and take
the necessary precautions.
Use only original Würth parts and ac-
cessories.

Tool Specifications

0714 640 130
635 nm
2 M
up to a working range of 30 m
±2 mm at 10 m
±2 mm at 10 m/±6 mm at 30 m
(plus the sensitivity of the hand receiver)
approx. 25 m at a wall clearance
of 10 m
3 x 1.5 V-typ LR 6 (approx. 20 h)
0 °C up to 40 °C
IP55
700 g
Do not look into the laser beam.
2)
7