Maintenance And Cleaning; Environmental Protection - Würth CLL 06 Notice D'utilisation

CLL 06.book Seite 9 Freitag, 21. Juli 2006 11:03 11
Project the cross onto both walls by rotat-
ing the tool and mark the points where the
laser beams intersect.
Set the tool up at a distance of 60 cm from
a wall and mark two new points.
Determine the height difference between
the marked points on both walls (D1 and
D2).
If the difference between D1 and D2 is
less than 2 mm, the tool is within the pre-
cision-tolerance range.
Checking the horizontal line
Place the tool in the mounting device and
and set it up at a distance of 5 m from a
wall.
Press the On/Off switch 5.
Mark the point where the laser beams in-
tersect and a point (A) on the horizontal
laser beam 2.5 meters away.
Rotate the tool so that the point where the
laser beams intersect is projected 5 m
away from the first point.
The deviation of the horizontal laser beam
from the point A marked previously may
not be greater than 2 mm.
Working Examples
Transferring a Height Line/
Height Point
Set up the line laser at the desired height
(e. g. on stand or with tripod). Mark the
points on the projected line.
Determine the height difference between the
laser beam and the height point, using a
straight edge. Rotate the line laser. Mark the
height difference determined previously.
Marking a Vertical Plane
Press On/Off switch 5.
Align the line laser parallel to the wall with a
laser beam. Mark the points along the other
beam.
Always clean the line laser after use. Remove
any moisture with a soft, dry cloth.
Do not use aggressive cleaning agents or
solvents.
If the machine should happen to fail despite the
care taken in manufacture and testing, repair
should be carried out by an authorized cus-
tomer services agent for Würth power tools.
In all correspondence and spare parts orders,
please always include the 10-digit order
number given on the nameplate of the machine.
The plastic components are labelled for cate-
gorized recycling.
Do not throw used batteries into house waste,
fire or water but dispose of in an environmen-
tally friendly manner according to the appli-
cable legal regulations.
For this Würth machine, we provide a war-
ranty in accordance with statutory/coun-
try-specific regulations from the date of pur-
chase (proof of purchase by invoice or deliv-
ery note). Damage that has occurred will be
corrected by replacement or repair.
Damage caused by normal wear, overload-
ing or improper handling is excluded from
the warranty.
Claims can be accepted only when the ma-
chine is presented undisassembled to a
Würth branch office or a Würth field service
employee.
Subject to change without notice
Maintenance
and Cleaning
Environmental
Protection
Recycle raw materials instead
of disposing as waste.
The machine, accessories and
packaging should be sorted for
environmental-friendly recycling.
Warranty
9