For Your Safety; Use As Intended - Würth PL 07 Notice D'utilisation

All manuals and user guides at all-guides.com
PL07.book Seite 7 Freitag, 5. Oktober 2007 9:50 09
GB
Working safely with the meas-
uring tool is possible only when
the operating instructions and
the safety notes are read com-
pletely and the instructions contained
therein are strictly followed.
The symbols used have the following
meaning:
DANGER:
Operational danger or improper usage that
can cause serious personal injury.
CAUTION:
Operational danger or improper usage that
can lead to minor personal injury, but cause
major material damage, financial loss or en-
vironmental damage.
Danger of blinding by the laser
beam.
Do not look into the laser beam
and do not aim the beam at other
persons or animals.
DANGER:
This measuring tool uses class 2 laser irradi-
ation in accordance with IEC 60825-1:
2001 and FDA 21 CFR Ch. I §1040: 2004. .
Do not look into the laser beam and do
not unnecessarily aim the beam at
other persons or animals. The natural
corneal reflex is not a sufficient protec-
tive measure.

Use as Intended

The unit is intended for determining and check-
ing precise horizontal and vertical partitions as
well as 90° arrangements and angles.
For damage caused by usage other then in-
tended, the user is responsible.

For Your Safety

Do not look into the laser beam with
optical aids, such as, e.g., binoculars.
Optical aids can focus the laser beam in
a dangerous manner for the eye.
Keep the device out of the reach of chil-
dren. They can cause danger to them-
selves and to others.
Never open the device yourself. The laser
beam is dangerous for the eyes. Have
damages repaired only through an
authorized Würth customer service agent.
CAUTION:
Do not drop the device. Perform check
measurements
important measuring tasks. Pay attention
to cleanness of the laser optics.
Protect the device against moisture.
Penetrating moisture damages the elec-
tronics. Always store and transport the
device in its protective case.
Do not remove the instruction label on
the bottom side of the housing.
Do not subject the unit to overly high
temperatures or intense sunlight.
Do not store the unit in cold environ-
ments/locations. When warming up,
condensate can form on the laser-exit
windows and lead to corrosion on the
circuit board.
Use only original Würth accessories.
Usage of accessories that are not rec-
ommended can lead to incorrect meas-
ured values.
before carrying out
7