Use Instructions - Vaporesso LUXE Q Manuel D'utilisation

USE INSTRUCTIONS

1. Install & Replace the Pod (Refer to FIGURE)
Pull out the pod from the battery and install the new one.
*If it's the first time using the device, please tear off the
sticker of the pre-installed pod.
2. Fill the E-liquid (Refer to FIGURE)
Snap off the mouthpiece and fill the e-liquid through the
filling slot.
*If it's the first time filling the e-liquid, please wait 5
minutes for the coil to prime.
3. Adjust the Airflow
The device has two different airflows. Rotate the pod
direction to change the airflow.
4. Start Vaping
The device is draw-activated. Inhale through the
mouthpiece and exhale to start vaping.
5. Check the Battery Level
The color of the LED indicator during vaping will indicate
the remaining battery capacity.
- Green Light: 70%-100%
- Blue Light: 30%-70%
- Red Light: 0-30%
6. Charge the device
Plug in the Type-C USB cable to charge the battery. When
it's fully charged, the light indicator will turn to green.
PROTECTIONS
Protections
Short-circuit
No Load
Low Voltage
Over Charging
Over Discharging
Low Resistance
High Resistance
Overtime
E N G L I S H
Flash Status of LED Indicator
Red Light x 5 times
Red Light x 5 times
Red Light x 3 times
Red Light ->
Red Light x 3 times
Red Light x 5 times
Red Light x 5 times
Current Color Light x 3 times
Green Light
English
1