Troubleshooting; Before You Send In The Appliance - Centronic Dirt Devil M2615 Instructions D'utilisation Et Consignes De Sécurité

5 Troubleshooting

5.1 Before you send in the appliance

5 Troubleshooting
Before sending the appliance to Royal Appliance Customer Services, use the following table to
check whether you can solve the problem yourself.
WARNING:
Danger of injury! Never use a defective appliance! Always switch off the appliance and disconnect
it from the mains before starting troubleshooting
power cord".
Problem
The appliance will The power cord is not plugged in. Insert the plug into a mains socket and
not start
The socket does not carry cur-
rent.
Power cord is damaged.
The vacuum The overheating protection has
cleaner stops sud- tripped (possibly due to blocked
denly suction channels, filters, or simi-
lar).
The results are The dust container is full.
unsatisfactory in
spite of the appli-
The filter is dirty.
ance working cor-
rectly.
Nozzle, telescopic tube or suction
hose are blocked.
The nozzle you are using does
not suit the flooring.
The "carpet / hard floor" selector
(Fig. 1/13) is in the wrong position
for the particular type of floor.
The appliance's Sucked-in objects are obstructing
running-sound is the air stream.
unusually loud.
The dust container is full.
Possible cause
Chapter 3.2, "Switching off and retracting
Solution
switch on the appliance,
"Vacuum cleaning".
Test the vacuum cleaner at another socket
which you are sure carries current.
Have the power cord replaced by Royal Ap-
pliance Customer Services, address,
Page 84, "International Service".
Switch the appliance off and pull the plug out
of the socket.
Eliminate the cause of overheating (e.g.
blocked suction channels, filters, etc.). Wait
for about 45 minutes. After the appliance
has cooled off, you may switch it on again.
Empty / clean the dust container
3.4, "Emptying the dust container".
Clean the respective filter,
"Cleaning and care".
Remove the obstacle. If necessary, use a
long wooden rod for this (e. g. a broomstick).
Change the nozzle Chapter 2.3, "Using
further nozzles (accessories)"
Set the "carpet/hard floor" selector (Fig. 1/
13) to the correct position for the type of
floor, Chapter 3.1, "Vacuum cleaning",
step 4.
Remove the objects. If necessary, use a
long wooden rod for this (e. g. a broomstick).
Empty / clean the dust container
3.4, "Emptying the dust container".
Chapter 3.1,
Chapter
Chapter 4,
GB
Chapter
81