emerio DH-127489.1 Mode D'emploi page 10

USE
1. Power button
Plug in the appliance, the machine will be in standby state. Press the power button, the power indicator light
will be on. Now users can press other buttons to choose the desired functions.
2. Mode button
Press this button to select your desired working mode; the corresponding indicator light will illuminate.
1) Auto dehumidifying mode:
When the ambient humidity＞set humidity + 3%, the compressor and fan start working as selected.
When the ambient humidity＜set humidity – 3%, the compressor stops working immediately and the
fan keeps working for approx. 30 seconds and then stops automatically.
Both wind speed and humidity can be adjusted under auto dehumidifying mode. After setting the
humidity the digital display will show back to the ambient humidity.
2) Continuously drying mode:
The appliance will run continuously and not be affected by the ambient humidity. Once the ambient
humidity reaches to 20% the appliance will stop automatically.
The wind speed can be adjusted under continuously drying mode and the digital display shows the
ambient humidity.
3) Sleeping mode:
The power indicator light and sleeping mode indicator light will turn dark; the other indicator lights and
digital display will be off if no further operations in approx. 10 seconds. Other functions are the same as
the auto dehumidifying mode.
4) Fan mode:
The humidity cannot be set and the compressor is not working.
The wind speed can be adjusted and the digital display shows the ambient humidity.
3. Humidity/timer increasing button and humidity/timer decreasing button
The set humidity can be adjusted from 30-80%.
The timer can be adjusted from 0-24h.
Note: long press the humidity/timer increasing button to check the ambient temperature.
4. Wind speed button
Press this button to switch the wind speed between low wind speed and high wind speed.
5. Timer button
Press this button to set the timer, check the timer or cancel the timer.
1) Set the timer:
Press this button to enter the timer setting state. The digital display will flash the timer value.
Press the button "+"/"-" to adjust your desired timer from 0-24h.
2) Check the timer or cancel the timer:
Once the timer has been set, users can press this button to check the remaining time of the timer.
Continue to press this button again the timer will be cancelled.
Note:
When the appliance is working set the timer to turn off the appliance.
When the appliance is standby set the timer to turn on the appliance.
- 9 -