Flex L 12-3 100 WET Notice D'utilisation page 5

L/LE 12-3 100 WET
(d) Remove any adjusting key or wrench
before turning the power tool on.
A wrench or a key left attached to
a rotating part of the power tool may
result in personal injury.
(e) Do not overreach. Keep proper
footing and balance at all times.
This enables better control of the
power tool in unexpected situations.
(f) Dress properly. Do not wear loose
clothing or jewellery. Keep your hair,
clothing and gloves away from moving
parts. Loose clothes, jewellery or long
hair can be caught in moving parts.
(g) If devices are provided for the con-
nection of dust extraction and collection
facilities, ensure these are connected
and properly used. Use of dust collection
can reduce dust related hazards.
4. POWER TOOL USE AND
CARE
(a) Do not force the power tool. Use the
correct power tool for your application.
The correct power tool will do the job
better and safer at the rate for which it
was designed.
(b) Do not use the power tool if the switch
does not turn it on and off. Any power
tool that cannot be controlled with the
switch is dangerous and must be
repaired.
(c) Disconnect the plug from the power
source and/or the battery pack from the
power tool before making any adjust-
ments, changing accessories, or storing
power tools. Such preventive safety
measures reduce the risk of starting the
power tool accidentally.
(d) Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands
of untrained users.
(e) Maintain power tools. Check for
misalignment or binding of moving parts,
breakage of parts and any other
condition that may affect the power tools
operation. If damaged, have the power
tool repaired before use. Many accidents
are caused by poorly maintained power
tools.
(f) Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to bind
and are easier to control.
(g) Use the power tool, accessories and
tool bits etc., in accordance with these
instructions and in the manner intended
for the particular type of power tool,
taking into account the working
conditions and the work to be performed.
Use of the power tool for operations
different from those intended could result
in a hazardous situation.
5. SERVICE
(a) Have your power tool serviced by
a qualified repair person using only
identical replacement parts. This will
ensure that the safety of the power tool
is maintained.
Instruction manual
5