Flex L 12-3 100 WET Notice D'utilisation page 15

L/LE 12-3 100 WET
17
When using the tool for a vertical
application, work the tool as shown
in Fig. 17.
18
DO NOT use the tool in an excessive
vertical application. Excessive vertical
use can lead to water and debris entry
to the motor through air intake as
shown in Fig. 18 and 19.
19
! NOTE
When using the device, wear rubber
gloves
1. Attach polishing tool.
2. Connect machine to the power
supply.
3. Connect the water.
4. Switch on the machine.
5. Open shut-off valve on the water
connection.
6. Firmly grip the bail handle and motor
housing as shown in Fig. 16.
7. Lower the tool until the polishing disc
contacts the work. Use light
pressure.
8. Always lift the polisher off the work
before starting or stopping motor.
20
The arrow on the front gear housing
indicates the direction in which the
polishing wheel rotates (Fig. 20).
Use only accessories that are
recommended by the manufacturer.
Accessories that may be suitable for one
tool may become hazardous when used
on another tool.
Instruction manual
!
15