Flex L 12-3 100 WET Notice D'utilisation page 13

L/LE 12-3 100 WET
9
5. If required, remove polishing tool.
10
6. Attach new polishing tool to the tool
holder.
If assembling the power tool for the first
time, perform Steps 3. and 4. only.
Function test:
1. Insert the mains plug into the socket.
2. Switch on the wet-polisher (without
locking the button) and leave it
running for approx. 30 seconds.
Check for imbalances and
vibrations.
Switch off the wet-polisher.
REMOVING THE BAIL HANDLE
Remove the bail handle if required.
11
1. Undo screws (1.) and remove the
bail handle (2.) .
12
2. Attach the handle cover with plastic
screws (3.).
CAUTION
If metal screws are used, there is a risk
of burns.
3. The device can now be used without
the bail handle.
Instruction manual
13