Troubleshooting; Load Cannot Be Lifted - Jungheinrich AM I20 Instructions De Service

5.7.3 Depositing a load
NOTE
Loads must not be deposited on travel or escape routes, in front of safety
mechanisms or operating equipment that must be accessible at all times.
Requirements
– Storage location suitable for storing the load.
Procedure
• Drive the truck carefully up to the storage location.
• Push the handle (21) in direction S (lower) to lower the
load handler.
Z
Do not set the load down abruptly in order to avoid
damaging the load and the load handler.
• Carefully remove the load handler from the pallet.
The load has been set down.
6

Troubleshooting

This chapter enables the user to locate and rectify basic faults or the results of
incorrect operation on his own. When trying to locate a fault, proceed in the order
shown in the table.
Z
If the industrial truck cannot be restored to operational status after carrying out the
following remedial operations, contact the manufacturer's service department.
Additional troubleshooting must only be performed by the manufacturer's specialist
service engineers. The manufacturer has a service department specially trained for
these tasks.
In order for customer services to react quickly and specifically to the fault, the
following information is essential:
- Truck serial number
- Error description
- Current location of truck.
6.1

Load cannot be lifted

Possible cause
Handle (2) in the wrong position
Excessive load
Action
Push handle to the "H" position
Note rated capacity, see data plate
S
21
31