Maintenance Schedule - Enarco TIFON 908 Manuel D'instructions

CLEANUP
NEVER allow concrete to harden on the power trowel.Immediately after use, wash any concrete off your
trowel with water. Be careful not to spray water on the engine. And old paintbrush or broom may help
loosen any concrete that has started to burden.
Coat the blades and blade arms with diesel fuel after cleaning. This should help prevent rusting and allow
for easier cleanup in the future. Maintenance (service, adjustment and repair)
NOTE: See the engine manual supplied with your machine for appropriate engine maintenance schedule.
There is a "daily preparation check list" at the end of this manual. Please feel free to make copies of it and
use it on a daily basis.

MAINTENANCE SCHEDULE

Daily (8-10 Hours):
Check the gearbox oil lever daily (1.5 liters of synthetic gear oil ISO VG 320).
Check the fluid levers in the engine and gearbox.
Weekly (50-60 hours):
en
Check the connect link control for loose.
Relubrication arms, thrust collar and clutch. Replace the blades if necessary.
Check and clean or replace the engine air filter as necessary.
Monthly (100-200 hours):
Remove, clean, reinstall an relubrication the arms, thrust collar and clutch.
Adjust the Blade arms.
Yearly (200-250 hours):
Check and replace, if necessary, blade arm bearings, thrust collar bearing, shaft retainers, and belts. Check
the blade tilt adjustment cable for wear.
DOUBLE POWER TROWELS TIFON908
12