Trowel Finisher Series-Instructions - Enarco TIFON 908 Manuel D'instructions

4

TROWEL FINISHER SERIES-INSTRUCTIONS

PUTTING INTO SERVICE: Before packing and shipping, this Power Trowel was run and tested at the
factory. If there are any problems, please let us know.Before putting your new finisher into service, read all
manuals and instructions carefully, Improper setup, use or maintenance of your equipment could result in
personal injury or damage to equipment.The purpose of this section of the manual is to explain the intend
setup, use and maintenance of this equipment.
ASSEMBLY
TIFON908 it is almost completely assembled. It is only necessary to fix the control levers in their correct
position (vertical).
DO NOT LIFT THE MACHINE BY GUARD RINGS!
BEFORE STARTING
Read and follow the engine operation manual before running.
1. Add fuel and water into the tank.
The tank on the left is for fuel, the
one on the right is for water.
en
2. Connect the battery wire. Red
wire is to positive, black is to
negative.
3. Add the oil to engine according to the engine manual. And check the
gear-box oil level.
4. Check the stop panel working properly.
5. Adjust the chair to the comfortable position for the operator.
DOUBLE POWER TROWELS TIFON908
10