Register Description; Function Register - ADEUNIS sigfox Europe RC1 Guide Utilisateur

FIELD TEST DEVICE - sigfox Europe - Guide utilisateur / User guide version V1.1.4
Example of a set of commands and corresponding responses that can be seen on the terminal:
Command syntax
\FF\FF\FF\FF+++
ATS202=3
ATT63 PROVIDER
FR
ATS202=3
ATS230?
AT&W
ATO
Interpreting the previous example: the user wanted to modify the number of repetition after having made an unauthorized command (answer
E), and the ranges were unblocked in order to modify the range. The range 230 was verified and the parameters were saved before exiting.
EN
When exiting command mode, the device will start a new transmission cycle.

5.4. Register description

Once supplied with power, the Field Test Device will function according to the last saved configuration (factory settings if this is the first time
the device has been switched on, or if this configuration has not been changed).
ATS<n>=<m> or ATR type modification commands allow you to modify the content of these ranges.
It is essential to save the parameters using the AT&W command before exiting the command mode, otherwise all of your changes will be lost.

5.4.1 Function register

Below is a list of the ranges accessible on the device (by default). These ranges make it possible to modify the device's behavior.
Details on how each range functions can be found elsewhere in the table.
Range
S370
S371
S380
S382
S383
S385
Description
Input request in command mode
The number of repetition change
Unblock the operating range
The number of repetition change
Feeds back the value of the S230 range
Memory request for the state range
Output request in command mode
Content
RESERVED
GPS configuration
Frame transmission period
Communication mode
RESERVED
Personalized Payload Size
Response syntax
CM
E -> This command is not validated (register no unlocked)
O
O
S230=868130000
O
O
Default value
0
0: GPS deactivated
1: GPS activated/Continuous Mode
11
0x00000101: GPS activated/Continuous Mode + GPS
Reset (Cold Start)
0: No periodic transmission
600
1 to 86400 (expressed in seconds) : Periodic transmission
0: monodirectional
1 1: bidirectional
1
0 : Deactivated
0
1 to 16 : Size of the payload
Comments
Page 44 of 47