Axis Q1614-E Guide D'installation page 22

AXIS Q1614-E Network Camera
1
Axis network camera
2
Network cable (route through wall bracket)
3
Cable holes
4
Bracket screw (4x)
5
Cable cover
6
Cable cover screw (2x)
7
Wall bracket
8
Bracket adjustment screw
1. Install the camera with the bottom cover on the bracket and tighten the bracket screws.
2. Remove the gasket from one of the holes in the bottom cover.
3. Route the network cable through the hole and plug the cable gasket to the hole.
4. Connect the cables, see Connect the Cables.
5. Take the top cover and attach the safety wire to the tab on the bottom cover.
6. Loosen the bracket adjustment screw to point the camera in the right direction. See
page 25 for information on how to view the video stream.
Adjust the focus, see page 24.
7. Install the top cover. Make sure to tighten diagonally opposite bottom cover screws a
few turns at a time until all are tight. This will help ensure that the bottom cover gasket
is compressed evenly. Do not tighten the screws completely the first time.
8. Install the cable cover and tighten the cable cover screws.
9. Loosen the sunshield adjustment screws and adjust the sunshield to the front position.
22