Boiling Water - SilverCrest SWK 2200 A1 Mode D'emploi

4) Fill the appliance with water once again, up to the MAX mark, and then
bring it to boil. When done, pour this water away also.
The appliance is now ready for use.

Boiling water

RISK - ELECTRIC SHOCK!
NEVER place the electrical base 6 in close proximity to water –Risk of
►
fatal electric shock!
WARNING - RISK OF INJURY!
► Always use fresh drinking water. Do not consume any water that has al-
ready stood in the kettle for longer than one hour. Do not reboil water that
has cooled down. Always pour old water away. It may contain germs!
NOTE
Always ensure that the on/off switch 4 is in the "O" position when the
►
mains plug is unplugged and the appliance is standing on the base 6.
If not, the appliance could heat up unintentionally as soon as the mains
plug is plugged in again.
1) Remove the kettle 7 to fi ll it!
2) Open the lid by pulling the release 2 upwards.
NOTE
Hold the kettle 7 upright when fi lling it. This is the only way to read the
►
markings on the scale 5 correctly.
3) Fill the kettle 7...
–
–
4) First close the lid and then place the kettle 7 on the base 6, such that it
stands securely on the base 6.
5) Now insert the plug into the mains power socket.
6) Move the On/Off switch 4 to position " ". The appliance starts to operate
and the indicator lamp 3 illuminates.
When the water is boiling, the appliance switches itself off automatically. The
On/Off switch 4 reverts automatically to the "O" position, the indicator lamp 3
switches off .
SWK 2200 A1
to at least the MIN mark, so that the appliance does not overheat,
no further than the MAX mark, so that boiling water cannot spill out.
GB
43