Koala Kare KB311-SSRE Instructions D'utilisation page 6

KB311-SSRE
Installation Instructions
Fig. 4
6 6
Step 6:
• Take the provided handle and position it over the
handle mounting studs.
• Use provided Allen wrench to tighten the set screws
in the handle, securing it to the handle mounting
studs. Fig. 4
Step 7:
• Test the unit by opening and closing multiple times,
ensuring it opens and closes smoothly.
• Remove protective film from the surface of the unit.
Step 8:
• To install the bag hook, measure up 44" (1118 mm)
from finished floor in the desired location and mark
the wall. Fig. 5
• Position the bag hook on the wall so that the top of
the mounting plate is level with the 44" (1118 mm)
mark.
• Position the bag hook over a wall stud for optimal
strength.
• Mark then predrill the mounting holes.
• Use the provided screws to secure the bag hook in
Fig. 5
position, then take the escutcheon plate and screw
it over the mounting plate to cover the mounting
screws. Fig. 6
Fig. 6
*Diagrams are not to scale. *Diagrams are not to scale.