Koala Kare KB311-SSRE Instructions D'utilisation page 5

KB311-SSRE
Installation Instructions
Fig. 1
Fig. 3
*Diagrams are not to scale.
Fig. 2
Step 1:
• Prepare the rough wall opening per the Technical
Data sheet. Make sure top of bottom stud is at 26
7/8" (683mm) to ensure correct mounting height.
Fig. 1 For more information navigate to www.
koalabear.com.
• Be sure to wear safety gloves to protect your hands
from the products exposed metal edge.
Step 2:
• Remove the handle and bag hook from the
packaging and set to one side.
• Open the unit by pulling up on the handle mounting
studs and remove the plastic liner dispenser from
inside the unit and set to one side.
Step 3:
• With the assistance of a second person, lift and
position the unit into the rough wall opening.
• Have one person hold the unit and place into the
wall while the other opens the unit using the handle
mounting studs.
Step 4:
• Open unit fully and you will have access to the six
mounting holes on either side of the unit. Fig. 2
• Using the hardware provided, predrill and screw
through the mounting holes. Do not over tighten.
• Once secured, the unit will no longer need to be
held in place.
Step 5:
• With the unit open, take the liner dispenser and
position it over the exposed metal frame in the
center of the recess.
• Use the provided key to open the liner dispenser.
This will provide access to the four mounting holes.
• Use the provided hardware to secure the liner
dispenser to the metal frame. Fig. 3
• Lock the liner dispenser and close the unit.
5 5