AXXAIR metabo DC25-M1 Mode D'emploi page 21

English
Then put in place and tighten the plate screw (tightening torque = 2.55 Nm, Torx
T15 screwdriver supplied).
Finally, replace the front part of the DC25, taking care to align the pin with its
groove.
Important note: these parts are precisely adjusted, so if they stick, do not force
them; remove the front part and try again.
F-26800 ETOILE-SUR-RHONE
- 21 -
Z.I. Les Bosses
www.axxair.com