Positioning And Removing The Dc25 - AXXAIR metabo DC25-M1 Mode D'emploi

English

3.4 Positioning and removing the DC25:

NOTE: always remove the battery before doing any work on the tool.
Doing this will prevent any accidental operation.
Fitting the DC25:
- Install the assembly on the drilling spindle as far as the stop
- Screw in the red ring, to lock the assembly.
Removing the DC25:
- Unscrew the red locking ring.
- Remove the DC25 from the machine.
- 18 -
Z.I. Les Bosses
F-26800 ETOILE-SUR-RHONE
www.axxair.com