Use; User Instructions - AXXAIR metabo DC25-M1 Mode D'emploi

English
4

USE

4.1 User instructions:

Note: When performing any operation on the DC25, take care that it is not fitted on
the power tool, so as to prevent any risk of an accident.
 Check the outside diameter of the tube to be machined.
 Choose the jaws depending on the diameter of the tube to be machined.
 Position the bottom jaw and then tighten screw IDIN912-M3x12 (tightening torque =
1.23 Nm, 2.5 mm Allen key supplied).

For the upper jaw, screw the nose of the raise and lower screw into the bore (so that
it rests against the upper jaw), then tighten screw IDIN912-M3x30 (tightening torque
= 1.23 Nm, 2.5 mm Allen key supplied).
Attention, if the jaw touches the inner face of the bore, the jaw tightening
system will be locked.
F-26800 ETOILE-SUR-RHONE
- 19 -
Z.I. Les Bosses
www.axxair.com