Niko 10-512 Mode D'emploi page 40

10-512
Programming an internal call and modifying the ring tone
For how to program an internal call, see 'Programming without service set (10-870)'. To
modify the ring tone for an internal call at the internal unit, press function key 3 (of the
basic module) for 8s. You hear a beep in confirmation of the setting. Press the blue door
opener key. The red and green LEDs light. Then press function key 1 (of the basic module)
to hear the first ring tone. With each new press on function key 1 (of the basic module),
you hear the next ring tone. To save the desired ring tone, wait until both LEDs go out
(±8s) and you hear a beep in confirmation of the setting. Note: communication is only
possible via one internal unit at a time. If the red LED on the internal unit blinks 3x, the
line is engaged by another internal unit.
Programming without service set (10-870):
Key:
Press key until...
Briefly press key
Let go of key
Next step
Programming the basic module
Step 1: Enter the internal unit's programming mode
Press function key 3 for 8s. until you hear a brief beep in confirmation.
Programming function
short operating description
Ring-and-come-in function
(de)activating with function key 1
If the bell is rung, the door
is automatically opened. The green
LED lights.
if this function is activated.
40
LED blinks
LED lights
Type of signal
Repeat
Step 2:
Press the key for 8s. until you hear
a brief beep in confirmation and
the green LED blinks. Let go of the
function key.
Let go of the function key.
Step 3:
Press a key for 8s. until you
hear a brief beep in confir-
mation and the green LED
goes out.
EN