Dry Ironing; Vertical Ironing; Self-Cleaning - Di4 Performance 3200 Manuel D'utilisation

control is set in high position, if the temperature level is in low position the appliance will automatica-
lly regulate steam to be according to the temperature level to avoid damaging clothes.
CAUTION: Avoid coming in contact with ejected steam.

DRY IRONING

The steam iron can be used on the dry setting with or without water in the water tank, it is best to
avoid having the water tank full while dry ironing.
Turn the variable steam control to the minimum position.
Select the setting on the temperature control dial best suited for the fabric to be ironed.
CAUTION: If the steam iron has been used for a long time, it is hot and there is no water. Do not refill
it with water until the steam iron cools down.
SHOT OF STEAM
The shot of steam feature provides additional steam for removing stubborn wrinkles.
Turn off the variable steam control to the min position
Press the powerful steam button to release the burst of steam.
NOTE: To prevent water leakage from the soleplate, do not keep the powerful steam button in conti-
nuously and wait almost 5 seconds between pressures.

VERTICAL IRONING

By pressing the shot-steam button at intervals you can also iron vertically (curtains, hung garments, etc.)
NOTE: To prevent water leakage from the soleplate, do not keep the powerful steam button in conti-
nuously and wait almost 5 seconds between pressures.
WHEN YOU FINISHED IRONING
Set the temperature dial to the minimum position.
Remove the main plug from the wall socket.
Stand the iron on heel rest.
MANITENCE AND CLEANING
It is recommended to the self-cleaning every two weeks if the water in the area is hard or semi-hard
if frequent use of the device is made
Before cleaning the steam iron ensure it is unplugged from the power supply and has completely
cooled down.
Do not use abrasive cleaners.
To clean exterior surfaces, use a damp soft cloth and wipe dry. Do not use any chemical solvents, as
these will damage the surface.
Cleaning the soleplate; Do not use scouring pads or harsh cleaners on the soleplate as these will da-
mage the surface. To remove burnt residue, iron over a damp cloth while iron is still hot. To clean the
soleplate, simply wipe with soft damp cloth and wipe dry.

SELF-CLEANING

Fill the half of the water reservoir.
Set the temperature control to its maximum position.
Insert the main plug into the wall socket.
18