Nikon DSB-N1 Mode D'emploi page 13

Attaching
En
Note) Refer to the circled numbers on the "Overview" page.
Note) All knobs and screws are loosened when they are turned
counterclockwise and tightened when they are turned
clockwise.
Preparing
1. Attach a non-skid pad on the shutter release button of the cam-
era. (Fig. 1)
2. Mount the fieldscope to the tripod.
Loosen c attaching knob for shutter release base B and
3.
dismount 4 shutter release base B from 1 bracket. (Fig. 2)
24
Fig. 1
Fig. 2
4
1
c
Digiscoping Bracket
1. Mount 1 bracket to the DS eyepieces.
Loosen 9 attaching knob for DS eyepiece and insert 0
eyepiece (DS mount) insertion all the way until the end. While
pressing against the insertion, fix the insertion with 9 attaching
knob for DS eyepiece. (Fig. 3)
[Note]
Make sure that 0 eyepiece (DS mount) insertion is securely
attached to the DS mount. If the insertion is not fixed securely,
the camera mounted may fall because of its own weight.
Loosen b slide fixing knob, slide 7 camera attaching base
2.
to the position shown in Fig. 4, and temporarily screw down the
camera attaching base.
Fig. 3
9
En
0
1
Fig. 4
7
b
25