Table des Matières
Publicité
Troubleshooting
d
WARNING
TO AVOID RISK OF ELECTRICAL
SHOCK !
EXPLOSION HAZARD!
Repairs or replacement of parts may
be carried out by authorized
technicians only.
Problem
Dryer does not start.
Dryer does not start.
start/stop" indicator light does not
start/stop" indicator light does not
illuminate.
illuminate.
Program has been interrupted.
A warning signal is emitted and the
A warning signal is emitted and the
display shows E:01".
display shows E:01".
Drum light does not function.
Drum light does not function.
start/stop" indicator light does not
illuminate. antiWrinkle" indicator
illuminate. antiWrinkle" indicator
lights.
lights.
The display shows 000".
Degree of drying has not been reached
or the drying time is too long.
or the drying time is too long.
Display may indicate E:03".
Display may indicate E:03".
Lint filter LED is blinking after lint filter
has been cleaned
Before calling the customer service,
d
check whether you can rectify the fault
yourself by means of the following
table.
If a fault cannot be rectified or a repair
is required:
Possible cause
Main plug not inserted at all or not inserted correctly. Insert main plug correctly.
A fuse of power supply has tripped.
start/stop" button not pressed.
No program selected.
Door not closed.
Ambient temperature below 41 °F/5 °C.
Lint filter dirty.
Exhaust air duct is blocked or too long.
Fault in program sequence or malfunction.
The room/cabinet is not adequately ventilated.
No program selected.
Light bulb defective, light bulb burned out.
No power supply.
Light bulb is loose.
Fault in program sequence or malfunction.
Moisture sensor dirty.
Exhaust air duct is blocked or too long.
Lint filter dirty.
Laundry was too wet.
Unsuitable program selected.
Maximum drying time was exceeded.
Motor limit temperature was exceeded.
Blinking of lint filter LED isnot an indication of a
problem. It is used only as a reminder.
1. Set program selector to off".
2. Turn off the circuit breaker.
3. Pull the mains plug out of the
socket.
4. Call customer service
(see page 20).
Remedial action
Replace/switch on fuse.
Press start/stop" button.
Select program.
Close door.
Increase room temperature.
Clean filter as described on page 18.
Switch off/switch on again.
Clean exhaust air duct. Reduce exhaust air duct to
maximum length as described on page 8.
Switch off/switch on again.
Switch off dryer, leave to cool down for 30 min,
switch on again.
Restart program.
Provide an adequate supply of fresh air.
Switch off/switch on again.
Select program.
Change light bulb, see page 18.
Guarantee power supply.
Tighten light bulb. Remove and reinstall the cover as
directed on page 24.
Switch off dryer, leave to cool down for 30 min,
switch on again.
switch on again.
Restart program.
Restart program.
Clean moisture sensor as described on page 18.
Switch off/switch on again.
Clean exhaust air extraction. Reduce exhaust air duct
to maximum length as described on page 8.
Switch off/switch on again.
Clean filter as described on page 18.
Switch off/switch on again.
Spin laundry at higher speed in the washing
machine. Switch off/switch on again.
Select program with aid of the program selection
table (see page 15). Switch off/switch on again.
Clean lint filter (see page 18).
Check exhaust air extraction.
Spin laundry at a higher speed in your washer.
Switch off dryer, leave to cool down for 30 min.
Switch on again. Start program.
No action required. Light will stop blinking.
19
Publicité
Table des Matières
