Whirlpool YNED4655EW Guide D'utilisation Et D'entretien page 11

TROUBLESHOOTING (cont.)
To possibly avoid a service call, first try the suggestions listed here or refer to the "Assistance or Service" page.
If you experience
Cycle time too short
Lint on load
Stains on load or drum
Loads are wrinkled
Odors
Load is too hot
Possible Causes
Automatic cycle ending early.
Lint screen clogged.
Dryer fabric softener not properly
used.
Dryer tightly packed.
Recent painting, staining, or
varnishing in the area where your
dryer is located.
Dryer being used for the first time.
Laundry items removed from the
dryer before the end of the cycle.
High temperature cycle used or was
TEMPERATURE control set to high.
The load may not be contacting the sensor strips. Level the
dryer.
Use Timed Dry for very small loads. Change the Dry Level
setting on Automatic Dry cycles.
Increasing or decreasing the Dry Level setting will change the
amount of drying time in a cycle.
Lint screen should be cleaned before each load.
Add dryer fabric softener sheets at the beginning of the cycle.
Fabric softener sheets added to a partially dried load can stain
your garments.
Drum stains are caused by dyes in clothing (usually blue jeans).
These will not transfer to other clothing.
Dry smaller loads that can tumble freely reduce wrinkles from
forming.
If so, ventilate the area. When the odors or fumes are gone
from the area, rewash and dry the clothing.
The new electric heating element may have an odor. The odor
will be gone after the first cycle.
Allow Cool Down cycle to finish before removing laundry from
dryer. All cycles are cooled slowly to reduced wrinkling and
make it easier to handle. Items removed before Cool Down may
feel very warm.
Select a lower temperature, and use an automatic drying cycle.
These cycles sense the temperature or the moisture level in the
load and shut off when the load reaches the selected dryness.
This reduces overdrying.
Solution
11