Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Perform Print Head Adjustment and Select the Connection Method
When the screen for selecting the
connection method appears, select the
connection method to use.
Wired LAN connection
This is the method for connecting the printer to the
network using a LAN cable.
1
Tap Wired LAN connection.
Check the message about the connection
method and tap Yes if there are no problems.
2
A message prompting you to connect the
LAN cable appears.
3
Use the LAN cable to connect the wired LAN
connector on the back of the printer to the
hub port.
4
Tap OK.
The paper starts feeding, and then the printer automatically starts charging the ink for the first time and adjusting the print head.
Charging the ink for the first time and adjusting the print head for the first time takes about 35 minutes.
• Do not open the covers of the printer or turn the power off while the ink is charging for the first time and the print head adjustment is executing.
Important
• If you selected Do not connect, the connection settings and software installation will need to be performed separately.
Note
Proceed to "Connect to the Printer" on p.12.
• Charging the system with ink fills the system from the ink tanks to the print head. In addition, cleaning is performed to keep the printer in optimal condition. This
may cause the remaining ink indicator and maintenance cartridge capacity indicator to drop some amount. The starter ink tank is for first-time installation. It is
recommended that you purchase replacement ink tanks quickly.
Wired LAN connection
Configure the printer and computer connection
settings and install the software while the ink is
charging for the first time and the print head is
adjusting.
Proceed to "Connect to the Printer" on p.12.
• If you are connecting the printer to the network using a fixed IP
address, select Do not connect. Configure the settings from the touch
Note
screen of the printer after the printer has finished charging the ink for
the first time and adjusting the print head.
Wireless LAN connection
This is the method for connecting the printer to the
network without using a cable.
1
Tap Wireless LAN connection.
Check the message about the connection
method and tap Yes if there are no problems.
2
A message prompting you to set up the
wireless LAN appears.
3
If you are configuring from a computer
-> Tap Yes.
If you are configuring from the printer
-> Tap No.
Wireless LAN connection
If you are configuring from a computer
-> Configure the printer and computer connection
settings and install the software while the ink is
charging for the first time and the print head is
adjusting.
Proceed to "Connect to the Printer" on p.12.
If you are configuring from the printer
-> Configure the wireless LAN settings from the printer
after the printer has finished charging the ink for the
first time and adjusting the print head.
Proceed to "Configure Wireless LAN Settings on the
Printer" on p.13.
11
USB connection
This is the method for connecting the
printer to a computer using a USB cable.
Only 1 printer can be connected.
Do not connect the USB cable yet.
1
Tap USB connection.
Check the message about the
connection method and tap Yes if
there are no problems.
USB connection
Configure the printer and computer
connection settings and install the software
while the ink is charging for the first time
and the print head is adjusting.
Proceed to "Connect to the Printer" on p.12.
Publicité
Table des Matières
