Binding Function - Reely X6 Notice D'emploi

13.

Binding Function

Transmitter and receiver in the hexacopter are already aligned with each other (bound) in the factory and can be
used at once. Renewal of binding is only required after replacing the electronic PCB in the model, when replacing the
transmitter or to remove a malfunction.
Re-establishing the binding:
To recover binding between the transmitter and the model, the flight battery must be unplugged and the transmitter
must be switched off. The hexacopter and the remote control transmitter must be in direct proximity to each other
(max. 1m distance).
• With the transmitter off, connect the flight battery to the hexa-
copter (see upper illustration). The blue LED (see figure 10,
item 4) is lit; the three green LEDs flash.
• Push the control stick for the pitch function at the transmitter
to the bottom position.
• Push the control stick for the nod function from above and
hold it in this position.
• Turn on the transmitter using the on/off switch with the nod
control stick pushed (also see figure 1, item 14). The trans-
mitter emits a signal sound and the green LED at the trans-
mitter lights up.
• When the three green LEDs at the hexacopter stop flashing
and are lit permanently, release the control stick for the nod
function.
• The on now performs a reconciliation of the sensors as for
any activation process.
• If the three red LEDs at the on are lit permanently after this
as well, binding has been recovered and the model is ready
to start.
Attention!
If you perform binding at the transmitter without the on being connected to the flight battery, a present
binding to the on is deleted and the LED in the transmitter lights up green with red flashing impulses. The
model then no longer reacts to the transmitter impulses and must be bound again.
Figure 25
61