Reely X6 Notice D'emploi page 54

Every operation of a button is confirmed by a short signal sound. The display shows the change of the yaw
trimming at the trimming display (see figure 5, item 6).
If the trimming button is pushed and held, the remote control will emit a quick sequence of signals and the
trim display will move sideways more quickly (quick adjustment). The trim middle setting is indicated by a
longer signal sound.
The set value for yaw trimming is automatically saved and must be re-adjusted after each activation of the
remote control.
Roll trimming:
If the hexacopter tries to drift or top to the right, reduce the speed until the hexacopter is safely on its landing struts
again. Now push the trim button for the rolling function (also see figure 1, item 5) to the left several times.
Push the pitch lever carefully forward and check if the adjustment was sufficient. Repeat the procedure until the model
does not show any tendency to drift to the right.
if the hexacopter tries to drift to the left, push the trim button for the rolling function to the right.
The display shows the change of the rolling trimming at the trimming display (see figure 5, item 4). The set
value is stored automatically.
54
Figure 17
Figure 18