Epson EX21 Guide Rapide

EX21
Quick Setup
Before using the projector, make sure you read the safety instructions in the
User's Guide on your projector CD.
Connect the projector
Choose from the following connections:
Computer USB Port
Connect the square end of a USB cable (not included) to the projector's
Type B (square) USB port. Connect the flat end of the cable to any
USB port on your computer (Windows
connect an audio cable.
Follow the on-screen instructions to install the Epson USB Display software.
(You need to install the software only the first time you connect.) After the
software has been installed, you will see your computer's screen displayed by
the projector.
Computer Monitor Port
Connect a computer using the VGA cable that came with the projector.
Connect one end to the projector's Computer (Component Video) port,
and the other end to your computer's
notebook, switch it to external display. You can also connect an audio cable.
Video Player
Connect up to 3 video devices and use the remote control to switch between
them.
RCA video cable S-Video
(composite video) cable
(optional) (optional)
*411741500*
*411741500*
® 2000 or later only). You can also
monitor port. If you are using a
Component video
Audio cable to VGA cable
(optional) (optional)
Turn on your equipment
1
Turn on your computer or video source.
2
Plug in the projector. The
3
Open the A/V Mute slide all the way.
4
Press the power button on the projector or remote control.
Power light
Power button
The projector beeps, the
warms up. When the power light stays green, the projector is ready to
use.
NOTE: To shut down the projector, press the
unplug it. You don't have to wait for the projector to cool down.
Adjust the image
1
If you don't see an image, press the Source Search button on the
projector or on the remote control to select the image source.
NOTE: If you still see a blank screen or have other display problems, see
the troubleshooting tips on the right.
2
To raise the image, press the foot release button and lift the front of the
projector. Release the button to lock the foot in position.
3
Turn the focus ring to sharpen the image.
Focus
To reduce or enlarge the image, press the Wide (enlarge) or Tele (reduce)
button on the projector's control panel.
4
If your image looks like
one side of the screen at an angle. Place it directly in front of the center
of the screen, facing the screen squarely.
5
If your image looks like
projector to correct it.
power light on the projector turns orange.
power light flashes green, and the projector
power button twice, then
or , you've placed the projector off to
or
or , press the buttons on the