Operation - PACLITE Equipment VR9000HD Manuel De L'opérateur

3c. After the engine has been started, make sure that the key is set to ON position during the
operation. (Setting the Key Switch to OFF position would not allow the generator to charge the
battery.)
4. Start the Engine – Manual Start
4a. Insert the Starting Handle to the starting bracket provided at the engine.
4b. While pulling the Decompression Lever with your left hand, rotate the Starting Handle slowly
until you hear the sound of fuel being injected.
4c. Release the Decompression Lever, and turn the Starting Handle with more force to start the
engine.
5. Move the Throttle Lever to LOW position, and let the engine run at idle for a few minutes to warm
up.
6. After the engine has warmed up, the machine is ready for operation.
7. Move the throttle lever to the high speed "H" position quickly to prevent damage from occurring to
the clutch. The "Full Throttle" position of this machine has been preset at the factory to achieve
optimum machine performance. DO NOT alter this setting since premature wear or tear can result,
and both engine and machine warranty will be automatically voided.
8. Move the Parking Brake Lever to the right to disengage it.
NOTE: Negligence to disengage the Parking Brake before attempting to
drive the machine forward or reverse will result in the severe damage to
the parking brake mechanism as well as the drive system.
9. Operators Control
9a. Throttle Lever
Always keep the Throttle Lever at High position during the operation. Do not attempt to alter the
travel speed by changing the engine revolution.
9b. Drive Lever
Move the Drive Lever forward to drive the machine forward.
For reverse motion, move the lever backward.
9c. Vibration Lever
By shifting the Vibration Lever to the ON position, the
vibration mechanism will be engaged and produce the
vibration.
10. Stopping the Engine
11. In preparation for stopping the engine, move the throttle
lever to LOW position.
12. Allow the engine to idle for 1-3 minutes.
13. Move the Throttle Lever to STOP position to stop the
engine. Then, set the Key Switch to "OFF" position. The
buzzer will sound when the Key Switch is set to ON while the engine is stopped.
14. Close the Fuel tap
15. Apply parking brake by swinging the Parking Brake Lever to the left.
Vibratory Roller Manual (2009 version)
Engage
Vibration
Lever
Safety Lever for
Reverse Motion
Disengage
Throttle
Lever
Forward/
Reverse
Lever
7