Gsm Card; Remote Control - Husqvarna HTC T8 Manuel De L'opérateur

HTC T8/RT8/X8/RX8
• SOS, signal sent to defined telephone number.
All commands can be given using both the remote control and via text message, however,
with one large difference.
When the remote control is used to activate Geofence alarm or sensor alarm, the machine is
locked. The machine is unlocked using the remote control's standby or with PIN code (see
machine manual).
Alarm is given via text message to the mobile numbers that are entered on the GPS tracker's
website. For further information, consult the GPS tracker manual.

7.3.4 GSM card

The GPS tracker communicates via GSM and requires a SIM card to work. The SIM card
enclosed in the packaging, when you buy the alarm in Sweden, is prepared so you can start
your alarm at once.
If you choose to use another SIM card than that enclosed on purchase, remember to adapt
the card as follows:
• The SIM card must have number presentation.
• Mobile answering machine (voice mail) must be switched off.
• The SIM card must not have a PIN code.
Most SIM cards work excellently with the GPS tracker, except for dedicated 3G operators.
With prepaid calling cards you avoid fixed monthly fees, but a SIM card connected to a
subscriptions is just as good.
When buying a SIM card, check that it has the right prerequisites by placing it in a mobile
phone.
• Deactivating the PIN code is usually done from the settings in the telephone's menu.
Contact your telephone operator if you need help.
• You can see if the card has number presentation and mobile answering machine by
calling the number from another telephone – check if the number is presented in the
display and if the mobile answering machine is activated.

7.3.5 Remote Control

Do as follows:
1 Check that the GPS tracker has started (the power switch is in position 1).
2 Press the remote control learning button (6). A green LED (RF LED) next to the remote
control learning button lights up.
3 While the green RF LED is still lit, press any button on the remote control. The RF LED
goes off and on to confirm that the pairing succeeded.
4 Wait until the green RF LED goes out.
5 The pairing is now completed and the remote control can be used.
50
Accessories
D003128, 02.00