Martin Yale papermonster TG10 391 Mode D'emploi page 6

GB
HOW TO OPERATE GUILLOTINE
TRIMMER
- Lift the handle of guillotine trimmer up. Place
material to be trimmed at the selected posi-
tion under safety guard and press the safety
guard with one hand while cutting. Press
down on sliding handle with the other hand
to cut. (see Fig 2)
Figure 2
- Take the guillotine trimmer on the lowest po-
sition, lift the lock button to the right and move
it from position B to A lock the guillotine trim-
mer after use. (see Fig 3)
Figure 3
TRIMMER
HOW TO OPERATE ROTARY
TRIMMER
- Place the trimmer on a stable flat surface
such as a table or desktop with rotary trim-
mer's work surface upward.
- Push and hold the cutting head to one side
of guide rail.
- Place material to be trimmed at the selected
position under the transparent clamp.
- Press the material to be trimmed with one
hand. Press down on cutter head with the
other hand and slide blade toward the other
side of guide rail. (see Fig 4)
Figure 4
- Do not make return trip cut with the trimmer.
Always begin cutting from the top of guide
rail.
6
CHOOSE THE CUTTING STYLE
- Multi-functional rotary trimmer includes three
styles: straight, perforated and wave.
- Pull up the locking switch and turn the ro-
tary toggle to choose the cutting style. After
choosing, press down locking switch and it
can be ready to use. (see Fig 5)
Figure 5
REPLACE THE CUTTING MAT
Cutting mat has 4 cutting positions (2 each side).
When blade does not cut cleanly you should ei-
ther rotate or flip mat over the new cutting sur-
face. When mat has been worn on all 4 cutting
surfaces, replace it. (see Fig 6/7)
Figure 6
TG10