Replacing The Bulb - Riccar Prima R50SS Manuel Du Propriétaire

MAINTENANCE OF THE FULL SIZE
POWER NOZZLE
Replacing the Power Nozzle
Belt Cont.
Insert the brushroll back into the brushroll
tray and place the belt guard back into
position (Fig. 1).
Spin the brushroll with your hand to make
sure it spins freely. Place the metal bottom
plate onto the unit (insert the front end
of the bottom plate first). Re-insert the
two bottom screws and secure (Fig. 2).

Replacing the Bulb

WARNING! To Reduce the Risk of Electrical
Shock or Injury from Moving Parts, Turn
the Vacuum Off and Unplug it.
Turn the power nozzle over and remove
the bottom plate by first unscrewing the
two bottom plate screws located by the
rear wheels (Fig. 2).
Remove the two top cover screws (Fig. 3).
Turn the power nozzle back over, push
the neck flat, and remove the top cover.
Simply pull the bulb out (no twisting)
and reinsert a factory-authorized bulb
(Fig. 4). Place the top cover back on the
unit, turn the machine over and re-insert
the two top cover screws. Reinstall the
bottom plate.
20
Fig. 1
Fig. 2
Fig. 3
Fig. 4