Riccar Prima R50SS Manuel Du Propriétaire page 19

OPERATION OF THE FULL SIZE POWER NOZZLE
Turning On the Power Nozzle
The power nozzle can only be turned on
if the canister is also turned on. The canister's
On/Off switch is located on the main body.
The power nozzle On/Off switch is located
on the handle. Simply press the switch
forward to engage the power nozzle.
Reclining the Wand
After turning on the canister and the
power nozzle, lower the wand by pressing
the left pedal on the back side of the
power nozzle (Fig. 1).
Removing and Inserting
the Wand
Remove the wand from the power nozzle
to use cleaning tools. Turn the power
nozzle and the canister off. Then, press
the wand release collar and remove the
wand and turn the canister on (Fig. 2).
To reinsert the wand into the power nozzle,
turn the canister off and press the wand
back into the neck of the power nozzle.
The wand will then click into place.
Carpet Height Adjustment
This power nozzle has six different
settings to clean a variety of carpet
types and floor surfaces. To adjust
the carpet height setting of the power
nozzle, press the right pedal located on
the back of the power nozzle (Fig. 3).
Each press of this pedal will adjust the
height to the next carpet height position.
The height indicator window shows the
current setting. You will see one of the six
settings detailed below (Fig. 4).
Setting: Intended Use:
1. XHI Very plush carpet
2. HI Plush carpet
3. Auto General carpet thickness
or bare floors
4. MED Medium pile carpet
5. LO Low pile carpet
6. XLO Indoor/Outdoor carpet
Fig. 1
Fig. 2
Fig. 3
Fig. 4
17