Main Features - Schauer Charge Master CM6A Manuel De L'utilisateur

gauge metal part of the frame or engine block.
 Connect charger AC supply cord to electric outlet.
 When disconnecting charger, turn switches (if supplied) to off, disconnect charger from AC power, remove
clip from vehicle chassis, and then remove clip from battery terminal. See operating instructions for length
of charge information.
 FOLLOW THESE STEPS WHEN BATTERY IS OUTSIDE VEHICLE. A SPARK NEAR THE BATTERY
MAY CAUSE BATTERY EXPLOSION. TO REDUCE RISK OF A SPARK NEAR BATTERY:
 Check polarity of battery posts. POSITIVE (POS., P, +) battery post usually has a larger diameter than
NEGATIVE (NEG., N, -) post. Some batteries are equipped with 'Wing-Nut' terminals allowing for easy
placement of the terminals to these posts.
 Attach at least a 24-inch long 18-gauge (AWG) insulated battery cable to NEGATIVE (NEG., N, -) battery
post.
 Connect POSITIVE (RED) charger terminal to POSITIVE (POS., P, +) post of battery.
 Position yourself and free end of cable as far away from battery as possible - then connect NEGATIVE
(BLACK) terminal to free end of cable.
 Do not face battery when making final connection.
 Connect charger AC supply cord to electrical outlet
 When disconnecting charger, always do so in reverse sequence of connecting procedure and break first
connection while as far away from battery as practical
 A marine (boat) battery must be removed and charged on shore. To charge it on board requires equipment
specially designed for marine use.

MAIN FEATURES:

 Easy to Use: Easy to operate and requires no technical experience.
 Fully controlled by Microprocessor
 Battery initial condition diagnose
 Enhanced battery rejuvenation (patented technology)
 Battery voltage retention analysis
 Long term maintenance
 Ultra lower power consumption ( ECO mode)
 Multi Charge Stages:
o Qualification - Battery condition check
o Battery rejuvenation
o Soft Start
o Bulk Charging
o Absorption Charging
o Equalizing Charging
o Voltage analysis
o Float Mode
 Diagnosis & Charge - Automatic diagnosis and charge: On power up, the charger
will automatically diagnoses the battery condition, and then determine if the battery
charger engages the rejuvenation stage or goes into charging cycle.
 Enhanced battery rejuvenation stage – Patented battery rejuvenation technology:
The charger has a unique and patented rejuvenation feature which uses with high
voltage equalizing and peak pulse reconditioning to repair the sulphated batteries,
this feature is fully automatic and subjected to the internal impedance of the battery.
Smart Charge plus Maintenance and Rejuvenation
4