Schauer Charge Master CM6A Manuel De L'utilisateur page 11

LED Status
1. Press to select the charge rate
2. Green
3. Green
4. Green
LED Status
5. Fault LED – Red
RED
RED Flashing
LED Status
6. Blue Flash / ON
7. Green Flash / ON
8. Green Flash / ON
LED Status
9. Green
10. Green
11. Green
12. Press to select the Battery type
QUALIFICATION
Checks
battery
condition to
determine
whether the
rejuvenation
stage or
charge cycle
is required.
ON Maintenance charge mode is selected
ON Silent charge mode is selected
ON Rapid charge mode is selected
ON Short circuit / Reverse polarity or Rejuvenation failed if Bulk LED also
flashing fast
Over temperature protection mode / Soft start charging timed out if Blue
bulk LED also flashing fast / Bulk charging LED timed out if Blue Bulk LED
also ON
Fast Flash – Rejuvenation / Slow Flash – Soft start charging
ON – Bulk charging
Flashing indicates Equalization charge or ON indicates Absorption
charging
Flashing if Analysis failed or ON if fully charged – Float / Maintenance
mode
ON Calcium battery type is selected
ON AGM or WET battery type is selected
ON GEL battery type is selected
REJUVENATION SOFT START
Automatic Increases
stage for your battery
batteries in life by gently
poor starting to
condition. charge the
Breaks down battery until
sulphation the battery
using new reaches a set
patented voltage.
technology.
Descriptions
Descriptions
Descriptions
Descriptions
BULK CHARGE ABSORPTION
Reduces Uses constant
charging time voltage and
by delivering ensures the
maximum battery
charge until receives a full
the battery charge
reaches a set without
voltage. overcharging
the battery.
EQUALISATION ANALYSIS
Restores full Checks the
capacity to battery
batteries by condition to
removing acid ensure it is
stratification. fully charged.
FLOAT
Maintains the
battery at
100% charge.
11