Additional Safety Instructions For Batteries And Chargers - Black & Decker CS1825ST1 Traduction De La Notice D'instructions Originale

Do not expose the tool to rain or high humidity.
Directive 2000/14/EC guaranteed sound
93
power.
Caution: Do not over tighten. Tighten by
hand. Finger tight only.
Switch the tool off. Before performing any
maintenance on the tool, remove the battery
from the tool.
Additional safety instructions for batteries and
chargers
Batteries
Never attempt to open for any reason.
u
Do not expose the battery to water.
u
Do not expose the battery to heat.
u
Do not store in locations where the temperature may
u
exceed 40°C.
Charge only at ambient temperatures between 10°C and
u
40°C.
Charge only using the charger provided with the
u
appliance/tool. Using the wrong charger could result in an
electric shock or overheating of the battery.
When disposing of batteries, follow the instructions given
u
in the section "Protecting the environment".
Do not damage/deform the battery pack either by puncture
u
or impact, as this may create a risk of injury and fire.
Do not charge damaged batteries.
u
Under extreme conditions, battery leakage may occur.
When you notice liquid on the batteries, carefully wipe the
liquid off using a cloth. Avoid skin contact.
In case of skin or eye contact, follow the instructions
.
below
Warning! The battery fluid may cause personal
injury or damage to property. In case of skin
contact, immediately rinse with water. If redness,
pain or irritation occurs seek medical attention. In
case of eye contact, rinse immediately with clean
water and seek medical attention.
Chargers
Warning! Your charger has been designed for a
specific voltage. Always check that the mains voltage
corresponds to the voltage on the rating plate.
Warning! Never attempt to replace the charger unit with a
regular mains plug.
Use your BLACK+DECKER charger only to charge the
u
battery in the appliance/tool with which it was supplied.
(Original instructions)
Other batteries could burst, causing personal injury and
damage.
Never attempt to charge non-rechargeable batteries.
u
If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Do not expose the charger to water.
u
Do not open the charger.
u
Do not probe the charger.
u
The charger must be placed in a well ventilated area when
u
charging.
Labels on the charger
The following symbols are found on your charger:
The charger is intended for indoor use only.
Read the instruction manual before use.
Electrical safety
Your charger is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on the
rating plate. Never attempt to replace the charger
unit with a regular mains plug.
If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Features
1. On/off switch
2. Lock-off button
3. Oil cap
4. Front guard
5. Chain tension adjustment ring
6. Chain
7. Guide bar
8. Chain sheath
9. Chain adjust locking knob
10.Chain cover assembly
11. Oil level indicator
12. Battery
Assembly
Warning! Always wear protective gloves when
working on your chainsaw.
Warning! Before performing any assembly
or maintenance on power tools, switch off and
remove the battery.
Warning! Remove the cable tie that attaches
the chain to the chainbar before assembly.
ENGLISH
11