Storage; Electrical Connection - Woodstar DIVAR 55 Traduction Des Instructions D'origine

• Do not use any aggressive cleaners, or sharp or
metallic cleaning utensils such as knives, hard
scrapers or similar. They could damage the sur-
faces.
1. Clean the plunge saw directly after each use.
2. Keep the protective devices as free of dust and
dirt as possible.
3. Rub the plunge saw off with a clean cloth or blow
it off with low-pressure compressed air. Wear pro-
tective goggles when using compressed air.
4. Use a damp cloth and a small amount of soft soap
if it is heavily soiled.
Note: Proper, regular care is not only important for
safe use, but also helps to extend the service life of
the plunge saw.
Replacing the connector cord
If the mains connection line of the plunge saw is dam-
aged, it must be replaced by the manufacturer, its
after sales support or a similarly qualified person in
order to prevent risks.
Checking the plunge saw
Regularly check the condition of the plunge saw.
Among other things, check to make sure:
• that the switches are not damaged,
• that the accessories are in proper condition,
• that the mains connection line and the mains plug
are not damaged,
• that the vents are unobstructed and clean. If appli-
cable, use a soft brush to clean them.
If you identify any damage, you must have the
plunge saw repaired by a specialist workshop to
prevent risks.
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables.
Wear parts*: Carbon brush, saw blade
* Not necessarily included in the scope of delivery!

12. Storage

Store the device and its accessories in a dark, dry
and frostproof place that is inaccessible to children.
The optimum storage temperature is between 5 and
30˚C.
Store the electrical tool in its original packaging.
Cover the electrical tool in order to protect it from dust
and moisture.
Store the operating manual with the electrical
tool.

13. Electrical connection

The electrical motor installed is connected and
ready for operation. The connection complies
with the applicable VDE and DIN provisions. The
customer's mains connection as well as the ex-
tension cable used must also comply with these
regulations.
Important information
In the event of an overloading the motor will switch
itself off. After a cool-down period (time varies) the
motor can be switched back on again.
Damaged electrical connection cable
The insulation on electrical connection cables is of-
ten damaged.
This may have the following causes:
• Passage points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been im-
properly fastened or routed.
• Places where the connection cables have been cut
due to being driven over.
• Insulation damage due to being ripped out of the
wall outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
Check the electrical connection cables for damage
regularly. Make sure that the connection cable does
not hang on the power network during the inspection.
Electrical connection cables must comply with the
applicable VDE and DIN provisions. Only use con-
nection cables with the marking „H05VV-F".
The printing of the type designation on the connec-
tion cable is mandatory.
AC motor
• The mains voltage must be 230-240 V~ 50 Hz.
• Extension cables up to 25 m length must have a
cross section of 1.5 mm .
2
Connections and repairs of electrical equipment may
only be carried out by an electrician.
Please provide the following information in the event
of any enquiries:
• Type of current for the motor
• Machine data - type plate
GB | 33