Maintenance; Storage; 11: Electrical Connection - Woodstar SD16V Traduction Des Instructions D'origine

GB
DE FR

9. Maintenance

Important.
Always pull out the power plug before starting any
cleaning work.
Cleaning
Keep all safety devices, air vents and the motor hous-
ing free of dirt and dust as far as possible.
We recommend that you clean the equipment immedi-
ately after you use it.
Wipe the equipment with a clean cloth or blow it down
with compressed air at low pressure.
Clean the equipment regularly with a damp cloth and
some soft soap. Do not use cleaning agents or sol-
vents; these may be aggressive to the plastic parts in
the equipment. Ensure that no water can get into the
interior of the equipment.
Servicing
There are no parts inside the equipment which require
additional maintenance.
Bearing(s)
Periodically lubricate the bearings of the guide rollers
with high-grade machine grease, at the latest howev-
er after 25 to 30 hours of operation.
Carbon brushes
In case of excessive sparking, have the carbon brush-
es checked only by a qualified electrician. Important:
The carbon brushes should not be replaced by any-
one but a qualified electrician.
Special accessories
Pin saw blade-universal
135 x 2,0 x 0,25 Z 10
blade mm 1 set = 6 pieces,
Pin saw blade- wood/plastic mm
135 x 2,0 x 0,25 Z 7
1 set = 6 pieces,
Pin saw blade-wood mm
135 x 3,0 x 0,5 Z 4
1 set = 6 pieces,

10. Storage

Store the device and its accessories in a dark, dry
and frost-proof place that is inaccessible to children.
The optimum storage temperature is between 5 and
30˚C. Store the electrical tool in its original packaging.
11. Electrical connection
The installed electric motor is completely wired ready for
operation.
The customer's connection to the power supply system,
and any extension cables that may be used, must con-
form with local regulations.
22 GB
Article No. 8800 0011
Article No. 8800 0012
Article No. 8800 0013
IMPORTANT REMARK:
The motor is automatically switched off in the event of
an overload. The motor can be switched on again after a
cooling down period that can vary.
DEFECTIVE ELECTRICAL CONNECTION
CABLES
Electrical connection cables often suffer insulation dam-
age.
Possible causes are:
• Pinch points when connection cables are run through
window or door gaps.
• Kinks resulting from incorrect attachment or laying of
the connection cable.
• Cuts resulting from running over the connecting cable.
• Insulation damage resulting from forcefully pulling out
of the wall socket.
• Cracks through aging of insulation.
Such defective electrical connection cables must not be
used as the insulation damage makes them extremely
hazardous.
Check electrical connection cables regularly for damage.
Make sure the cable is disconnected from the mains
when checking.
Electrical connection cables must comply with the regu-
lations applicable in your country.
SINGLE-PHASE MOTOR
• The mains voltage must coincide with the voltage
specified on the motor's rating plate.
• Extension cables up to a length of 25 m must have a
cross-section of 1.5 mm2, and beyond 25 m at least
2.5 mm2.
• The connection to the mains must be protected with
a 16 A slow-acting fuse.
Only a qualified electrician is permitted to connect the
machine and complete repairs on its electrical equip-
ment.
In the event of enquiries please specify the following
data:
• Motor manufacturer
• Type of current of the motor
• Data recorded on the machine's rating plate
• Data recorded on the switch's rating plate
If a motor has to be returned, it must always be dis-
patched with the complete driving unit and switch.