oneConcept Beaufort Mode D'emploi page 42

EN
42
(X) Setting
Switch between the display modes current wind speed / average wind
1
speed
2
Switch between the display in Km/h, Mph, m/s, knots, Beaufort
High wind speed alarm: Use +/- and ON / OFF to set the wind speed
3
at which an alarm sound should be emitted. When the alarm is active,
a corresponding icon is shown on the display.
Alarm for wind from a specific direction: Use +/- and ON/OFF to
set the compass direction at which an alarm sound is to be emitted.
4
When the alarm is active, a corresponding icon is shown on the
display.
Display of the highest wind speed measured so far (flashing). Press
5
and hold the display for 3 seconds to return to the normal display.
(X) = The number of times the display must be tapped to access the
corresponding settings
Wind speeds