Erasing Diagnostic Trouble Codes And Data - Actron OBDII PocketScan CP9125 Mode D'emploi

en
NOTE: If there are no more
I/M monitors that are incom-
plete, the tool will then
display ready monitors when
is pressed .
10 . View I/M monitors that are
ready .
• Press and release
NOTE: Pressing
scroll up to review diagnostic
trouble codes and data .
Holding
seconds will read diagnostic
trouble codes and data again .
Erasing Diagnostic Trouble
Codes and Data
Erasing allows the PocketScan®
code reader to delete the codes and
IM monitor status from the vehicle's
computer modules .
NOTICE
Only erase diagnostic data
after checking
system completely and
writing down results .
Bosch Automotive Service Solutions
.
will
down for 3
| CP9125 | User guide | 9
WARNING!
Avoid cooling fan . Fan
may turn on during test .
1 . Turn ignition key to the OFF
position .
2 . Locate and plug in data link
connector (DLC) .
NOTE: The data link connector
should be located under the
dashboard on the driverside of
the vehicle . If the data link
connector is not located under
the dashboard as stated, a label
describing the location of the
data link connector should be
there .
3 . Observe display toggles between
"Pocket" and "Scan" .
4 . Turn ignition key to the ON
position leaving engine off .
NOTE: Make sure that the igni-
tion key is ON and NOT in the
accessory position .
577256 REV C | 03.2016