Fein GRIT GX 75 Serie Manuel D'instructions page 10

GX75.book Seite 10 Freitag, 18. April 2008 11:14 11
us
6. Intended use of the machine.
The belt grinder GX is a multi-functional grinding machine specifically designed for metal grinding.
The grinding machine can be integrated with extra modules for special grinding operations.
The grinding machine is designed for industrial indoor use in moisture free surroundings.
The grinding machine is only for metal grinding and must not be used for grinding of wood or plastic
materials.
7. Adjustments.
Before any work on the machine itself, pull the power plug from the socket outlet.
WARNING
7.1 Adjusting the incline (Figure 5).
Loosen both clamping levers. Adjust the
machine to the required working height.
Tighten both clamping levers again.
7.2 Adjusting the grinding rest (Figure 6).
The gap size must always be
WARNING
adjusted to the correct size. Thin
workpieces could be pulled into the machine
and cause severe or fatal injury.
Loosen star-knob bolt and adjust the gap
size to 2 mm (max.) .
Tighten the star-knob bolt again.
10
Adjustment knob
for grinding rest
GX 75
Fig. 5
Clamping lever
Fig. 6
WARNING
max 2 mm