Support / Input; Supported Program; Software Upgrade - Samsung 5 Serie Manuel De L'utilisateur

Support / Input

Supported Program

Self Diagnosis
❑
Picture Test
„
If you think you have a picture problem, perform the picture test. Check the Colour pattern on the screen to see if the problem still
exists.
Does the problem still exist with this test photo?
N
If the test pattern does not appear or there is noise in the test pattern, select Yes.
If the test pattern is properly displayed, select No.
• Yes : There may be a problem with the TV. Contact Samsung's Call Center for assistance.
• No : There may be a problem with your external equipment. Please check your connections. If the problem still persists, refer
to the external device's user manual.
Sound Test
❑
If you think you have a sound problem, please perform the sound test.
You can check the sound by playing a built-in melody sound through the TV.
Does the problem still exist with this sound test?
N
If during the sound test you can hear sound only from one speaker or not at all, select Yes.If you can hear sound from the
speakers, select No.
• Yes : There may be a problem with the TV. Contact Samsung's Call Center for assistance.
• No : There may be a problem with your external equipment. Please check your connections. If the problem still persists, refer
to the external device's user manual.
If you hear no sound from the TV's speakers, before performing the sound test, make sure Speaker Select is set to TV speaker
N
in the Sound menu.
The melody will be heard during the test even if
N
the M MUTE button.
Signal Strength (Digital channels only)
„
You can adjust your antenna to improve the reception of available digital channels.
If the signal strength meter indicates that the signal is weak, physically adjust your antenna to increase the signal strength.
N
Continue to adjust the antenna until you find the best position with the strongest signal.

Software Upgrade

❑
To keep your product up-to-date with new Digital Television features then software upgrades are periodically broadcast as part of
the normal Television signal. It will automatically detect these signals and display the software upgrade banner. You are given the
option to install the upgrade.
By USB
„
Insert a USB drive containing the firmware upgrade into TV. Please be careful to not disconnect the power or remove the USB drive
while upgrades are being applied. The TV will turn off and turn on automatically after completing the firmware upgrade. Please
check the firmware version after the upgrades are complete. When software is upgraded, video and audio settings you have made
will return to their default (factory) settings. We recommend you write down your settings so that you can easily reset them after the
upgrade.
By Channel
„
Upgrades the software using the broadcasting signal.
If the function is selected during the software transmission period, this function
N
searches for available software and downloads the software.
The time required to download the software is determined by the signal status.
N
Standby Mode Upgrade
„
To continue software upgrade with master power on, Select On by pressing the ▲ or
▼ button. 45 minutes after entering standby mode, a manual upgrade is automatically
conducted. Since the power of the unit is turned on internally, the screen may be on
slightly for the product. This phenomenon may continue for more than 1 hour until the software upgrade is completed.
appears on the screen.
appears on the screen.
Speaker Select is set to External Speaker or the sound is muted by pressing
English - 26
TV Side Panel
USB Drive