Black & Decker 9049 Guide D'utilisation page 5

154433/-9049 SHORT2 12/8/03
LOCK OFF BUTTON
2
FORWARD
TRIGGER SWITCH
10:05 AM Page 3
REVERSE
TRIGGER SWITCH
Lock Off Button
1
To prevent accidental turn on, a lock off button is provided. To lock
the drill off slide the button up. To unlock the tool, slide the button down
(Figure 1).
Trigger Switch & Reversing Button
The drill is turned ON and OFF by pulling and releasing the trigger
switch shown in Figure 2. The reversing button, shown in Figures 2 & 3,
switches the drill's direction from forward to reverse.
Two Speed Operation
Your drill is equipped for two speed drilling. To operate at low speed,
squeeze the trigger switch halfway. This will produce a speed of
approximately 225 RPM to be used for driving screws and starting
holes without a centerpunch. Squeezing the trigger switch all the way
will produce a speed of approximately 550 RPM (450RPM for the
catalog number 9045) for normal drilling operations.
NOTE: There is a slight pause between speeds. Keep squeezing the
3
trigger, and the drill will start again.
Screw Driving
For driving fasteners, the reversing button should be pushed to the left
as shown in Figure 2.
Use reverse (button pushed to the right) shown in Figure 3 for
removing fasteners. When moving from forward to reverse, or vice
versa, always release the trigger switch first.
Chuck & Key
Turn chuck key counterclockwise to open chuck jaws, place bit in chuck
as far as it will go and then pull it out far enough so that the chuck jaws
3