Changing Modes - Hofmann EEWB746A Mode D'emploi

F2
99
7-2
4-4
1
2
4-15
Trouble shooting

7.3 Changing modes

Normal operation usually does not require any
modification of the factory-adjusted modes of operation
or their factory-adjusted state. in special cases, or if
the need arises, different modes of operation or states
may be changed by entry of a code.
inputs and readings when a mode of operation is
changed (Fig. 7-2 – example code C14)
• Press the "SETTiNGS" key (F2, Fig. 4-4) three
times.
• "C 14" appear in the monitor.
• Press the menu key - or + (1, 2, Fig. 4-15) until
the required C number is reached or Rotate the
wheel to set the desired code in the display.
• The C state is read out on the screen. For some
codes a given value can be set.
• Do the proposed changes.
• Press the oK key to set the value.
To return to the normal working mode:
Press the ESC key.

Having completed the input of mode of operation it will
remain stored until the machine is switched off with the
main switch, or until a new input is made.
The changed modes can also be stored permanently
with code C10, so that they are not cancelled when the
machine is switched off but are retained in a permanent
memory for future use until a new input is
made and stored. Settings changed, but not saved in
the permanent memory will be reset to the previous
value when the machine is turned off.
Code C4 cannot be stored in the permanent
memory.
The possible changes of codes and the necessary
inputs are described in the following.
Operator's Manual
EEWB746A