Zibro Kamin R 316 C Manuel D'utilisation page 50

1 1
3 3
4 4 b b
5 5 b b
6 6
8 8
4
48
R 316 C
REPLACING THE WICK
L
ENSURE THAT THE HEATER IS OFF AND COMPLETELY
COOLED BEFORE STARTING TO REPLACE THE WICK.
Open the lid and remove the removable tank.
1
2 2
Remove the batteries from the battery holder.
2
Check that both the ignition slides are in the uppermost
3
position. Pull off the plastic covers of the slides.
4 4 a a
4 Open the front grill. Remove the combustion chamber
from the heater. Close the grill.
Unscrew the screws on the back and sides of the heater.
5
5 5 a a
Pull the cabinet forward slightly and remove it from the
base plate. Unscrew the wing nuts from the wick holder
chassis.
Lift the wick holder chassis up until the wick is visible.
6
Place the wick holder chassis next to the heater. (Ensure
5 5 c c
that the wiring does not become disconnected).
Push the lowest slide down to adjust the wick
7
mechanism to its highest setting.
7 7
Turn the wick holder (with wick) to the left until it is
8
released and then remove it from the heater.
9 Remove the wick from the wick holder.
9 9