GMV DOC 10990984 Manuel D'installation page 8

4
Pag. 2 di
EN
Doc. n° 10990984
Rev.1.0.3 - 25.09.2006
1.1.1.2 CAR STOP MECCANICAL DEVICE
The mechanical device to stop the car, according with the
EN81-2/A2:2004 rules consisting of three principal parts:
A) The mechanical stop (EN81-2/A2:2004 6.4.4.1), with
electrical switches (EN81-2/A2:2004 6.4.4.1 e) f) g) h)
i)), that is secured to the guide rails at a distance from
the lower floor that warrant all the request of the
EN81-2/A2:2004 6.4.1 e 6.4.2 rules.
B) The device that guide the deferring ropes, that is
secured to the guide rails
C) The activating handles that allow to the mechanical
device to start or stop working from an easy location
The installation of the mechanical device to stop the car,
should be made according with all dimension shown in
the section 1.1.1.3.
Fig. 1.5 -
Mechanical
device working
Fig. 1.6 -
Mechanical
device not
working
ATTENTION
The car stop mechanical device works only with GLT car frames.
ATTENTION
The car stop mechanical device works only if the hex cap screw M8x70 and the self-locking nut are
installed on the safety gear acting lever.
ON
ON
ð
ò
OFF
ï
OFF
OFF
ð
ò
ON
ï
Installation Manual
MRL devices
ò
Fig. 1.4 – Mechanical device
CPA
4V 5V
ð ï
7V 8V
ð ï
CPC
3