Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CONTENTS
1
SAFETY PRECAUTIONS - BEFORE YOU BEGIN
2
INSTALLATION INSTRUCTIONS
2
APPLICATION AND PURPOSE
3
STEP 1 - CABINET OR WALL OPENING
3
STEP 2 - EXHAUST DUCT ASSEMBLY
5
STEP 3 - SURFACE INSTALLATION
SAFETY PRECAUTIONS - BEFORE YOU BEGIN
When properly cared for, your Hestan appliance will provide safe, reliable service for many years. When using
this appliance, basic safety practices must be followed as outlined below.
IMPORTANT: Save these instructions for the local Gas or Utility Inspector's use.
INSTALLER: Please leave this Installation Manual with the owner.
OWNER: Please retain this Installation Manual for future reference.
Do NOT install this appliance outdoors.
ELECTRICAL SHOCK HAZARD
Disconnect power before installing or servicing appliance. Failure to do so can result
in electrical shock or death. It is the responsibility of the user to have the appliance
connected by a licensed electrician in accordance with all applicable codes and
standards, including fire-related construction, or in the absence of local codes, in
accordance with the National Electrical Code.
ELECTRICAL GROUNDING
•
This appliance must be grounded. Grounding reduces the risk of electric shock
in the event of a short circuit. Read the ELECTRICAL SUPPLY section of the
appliance installation manual for complete instructions.
•
This appliance is equipped with a 3-prong grounding plug for your protection against shock hazard and
should be directly plugged into a properly grounded receptacle. Do not cut or remove the grounding
prong from this plug.
ELECTRICAL SUPPLY
The appliance must be on its own dedicated circuit - 120 VAC, Single Phase, 60 Hz, with a current rating of 15
Amps. Have the installer show you where the electric circuit breaker is located so you know how to shut off
the power to this appliance.
©2019 Hestan Commercial Corporation
EN
1
Publicité
Table des Matières
